![]() ![]() Second test: Windows XP running in iSCSI – LAN optimized You can compare or post your results from this test with other VMWare users on this site: VMWare Unofficial Storage Performance thread.Ī first run of the test within our Windows XP installation shows the following, promising values:Ī good first run! As we have installed Freenas, VMWare and the virtual machine without any additional configuration, optimization or tweaking what so ever, we think there is room for improvement. To get a good impression of the performance, we installed IOMeter (2006.07.27) and ran the unofficial but generally accepted VMWare Performance test using the 8GB test file from VMKTREE.ORG. So the complete virtual machine is stored on and running from this iSCSI datastore. This ‘slice’ will be our first iSCSI disk in VMWare 5.Īfter attaching the disk to VMWare, we installed Windows XP on our vMWare server, using the iSCSI storage as datastore for this virtual machine. We wanted to take it easy on the first test, so we configured the Freenas server to use iSCSI and configured a 250GB ZFS Volume on top of our ZFS RAID. We are ready to go! First test: Windows XP running on iSCSI We attached the second gigabit LAN interface of the Freenas storage and the VSphere server to this switch to create a simple iSCSI LAN. The switch is capable of Jumbo Packets (up to 9,720 bytes), but we will not be using it (yet!). This little switch will be our first link between the ESXi/VSphere server and the Freenas storage. ![]() We installed an internal 2GB USB stick in the D元60 and installed VMWare VSphere 5 (aka ESXi 5) on the box and configured or tweaked nothing besides the basic network settings.Īs for our network, we have purchased a small NetGear GS108 ProSafe 8-port Gigabit Ethernet switch. The following was the result of a support call with HP and current recommendations for Running 5.With this used hardware we have a dedicated test server we can use to put our Freenas Storage through all different kinds of test. Server Asset Text>Server Name> Īdvanced Options>Advanced System Rom Options> Server Security> Intelligent Provisioning F10 Prompt> Disable > Memory power savings mode-> Maximum Performance > Minimum Processor Idle Power Package State -> No Package State > Minimum Processor Idle Power core State -> No C-States > HP Power Regulator -> HP Static High Performance Mode > HP Power Profile -> Maximum Performance > Intel Virtualization Technology> enabled System Options>Embedded Nics>Network Boot> Disabled Here's a base config that I received from HP Support that went over basic Bios configuration setting for the proliant DL560\580 G8 series combined with cookbook and flags for compatible fw versions There was a recent bug in firmware for the the iLO that would cause a spontaneous reboot on G8 iLO4 systems ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |